news

Specification for the use of plastic capping and capping machine

Update:13-07-2019

With the continuous improvement of the performance of the trademark die-cutting machine, the plastic capping machine has been widely used in the industry, which has brought about an increase in output. Since the die-cutting process is the most commonly used process for packaging printed matter. It is a molding process in which a die-cutting knife is combined into a die-cutting plate according to the design requirements of the product, and the printed matter or other ring-shaped blank is rolled into a desired shape or a cut by a pressure.

The plastic capping and capping machine uses a steel knife, a metal mold, a steel wire, and applies a certain pressure through the plate to cut the printed product or the cardboard into a certain shape. If the entire printed product is cut into a single graphic product, it is called die cutting; if the steel wire is used to press the mark on the printed product or leave the bent groove marks as indentation; if the two templates are used, the mold is passed. When heated to a certain temperature, a pattern or font with a three-dimensional effect on the surface of the printed product is called bronzing. If one substrate is used on another substrate, it is called a bonding, so it needs to be selected according to the actual situation. Proper equipment to ensure that it is trouble free in production.

When the trademark die-cutting machine is in operation, it needs to follow a series of operation specifications. Before the operation, fill in the first inspection record, and continuously check the product half an hour before the operation. During the sampling process, the problem is continuously found and solved. The root cause of the problem, and fill in the record of re-examination, in normal operation, each time using the time of loading, the product is further sampled, and the curved plate is adjusted to the speed suitable for paper feeding to prevent safety hazards. produce.

The plastic capping and capping machine should be carefully checked for the semi-finished products of the printing shift. The displacement should be classified to reduce the loss. According to the production quantity of the work order, the quantity to be produced should be set. When the garbage bin of the work is full, it must be shut down to prevent potential safety hazards. Ensure that the requirements for the paperboard and work order are the same, the die-cut dimensions are the same as the die-cutting drawings, the position of the die-cut printing surface is consistent with the position of the printed draft, whether the pressure line is centered, the depth is suitable, the folding is easy, and the cardboard does not burst. It must not be broken, no unnecessary creasing lines, smooth edges and no burrs, so that the products meet the requirements of the industry.

0
Specification for the use of plastic capping and capping machine
Contact US