News -

Description of the compression performance of the plastic cap of the capping machine
10-08-2019
The cap of the capping machine is produced by the same manufacturer and the plastic bottle cap produced by the same production site. The shape of the compression curve (load-displacement curve) is bas...
Process of injection molding of capping and capping machine
16-08-2019
The first stage of the capping machine is melt injection. The plastic melt is injected into the plastic bottle cavity, which is the same as the conventional injection molding. However, the melt is onl...
Introduction of the assembly steps of the plastic cap compression machine mold
24-08-2019
About installation and testing 1. The plastic cap compression machine should be installed in the same way as the drawings. 2. The plastic bottle cap mold should be aligned with the horizontal plane wh...
Method for polishing shaped tube of capping machine
30-08-2019
The capping and capping machine utilizes the microscopic protrusion on the surface of the shaped tube to perform an electrochemical process, which is also called electropolishing, in the specific elec...
Structural knowledge of plastic bottle cap molding machine PET plastic for cap packaging equipment
06-09-2019
The PET plastic cap moulding machine has a highly symmetrical plastic molecular structure and a certain crystal orientation, so it has a high film forming property. PET plastics have good optical prop...
Plastic bottle cap design process
21-09-2019
CSD mouth The internal pressure of the bottle can reach 5 bar, and the sealing performance is better as the internal pressure increases. All CSD mouths have at least two turns of thread and have a ven...